Cabot's
Exterior Clear Satin
1 of 1
Cabot's
Exterior Clear Satin
About Cabot's Exterior Clear Satin
Cabot's Exterior Clear is a highly durable, marine grade polyurethane that provides protectionwithout hiding the grain for exterior doors, windows and trim. It is designed to provideresistance against weathering and moisture damage and contains ultra-violet absorbertechnology to maximise gloss, performance and durability. It's specially formulated resin systemensures high gloss retention and superior clarity to enhance the richness and natural texture ofthe timber.
Key Points
- Superior 3 Coat System
- UV Protection
- Dirt and Mould Resistant
- Enhance timber grain
Application
Brush
Spray
Touch Dry
4 Hours
Re-coat
12 Hours
Product specification
Precautions and limitations
Do not apply this product in temperatures below 10°C or above 35°C, or when rain or heavy dew is expected during the drying period. If using outside in hot temperatures, do not apply in direct sunlight. Cabot's Exterior Clear is not suitable for: • Previously wax coated finishes • Walk-on areas • Outdoor furniture • Broad wall application such as cladding or weatherboards • Areas subject to long term immersion in water
Performance guide
- Weather: Excellent
- Salt: Unaffected by splash or spillage
- Water: Good
Surface preparation
Previously painted surface
Note: Fill holes and imperfections with a suitable timber putty.
Previously painted or varnished timber
Remove back to bare timber using a paint stripper, or sanding. For exterior surfaces clean with Cabot's Deck Clean following label instructions.
Previously stained or oiled timber
For exterior surfaces clean with Cabot's Deck Clean following label instructions, then allow timber to fully dry. Test if the surface is ready for coating by sprinkling water on the timber. If the water beads on the surface, repeat the application of Cabot's Deck Clean. If the water is absorbed into the timber, it is ready for coating. For a more transparent look, sand timber back to bare before coating.
Weathered and grey timber
For best results, sand timber back to a fresh substrate. For exterior surfaces clean with Cabot's Deck Clean following label instructions.
Unpainted surfaces
Bare timber
To coat new bare timber immediately, scrub damp timber with Cabot’s New Timber Prep, following label instructions. New Timber Prep will draw out tannins and oils quickly from the surface, allowing you to skip the 4-6 weeks weathering process required for new timber. Always follow New Timber Prep with Cabot’s Deck Clean following label instructions.
How to apply
Brush, Roller
Apply by brush or spray.
Stir thoroughly with a broad flat paddle before and during use.
Always brush in the direction of the grain. Apply 3 liberal coats, allowing 12 hours between coats.
Sand lightly between coats.
Maintenance
Regular inspection of all coated surfaces is recommended. Pay particular attention to sharp edges. If minor damage is detected, touch up immediately with Cabot's Exterior Clear.